A skeleton bust in a thoughtful pose, with a chin-resting hand and a large offset bowl held out to the side. It sits on a round base, so it stands on its own on a desk, shelf or table. The skull, ribcage and finger bones are sculpted in detail, and the bowl is wide and shallow with a gently wavy rim.

Use cases:

Candy, treats or snack dish for Halloween parties and trick-or-treatingHolder for keys, rings, jewelry or loose change on a desk, dresser or entryway tableSpooky desk or shelf decoration, or a gift for gothic and horror fansTea light or small plant holder, using a liner for anything wet

Recommended print settings:

Material: PLA for decoration. Use PETG if the bowl will hold heavier items like keys or coins.Layer height: 0.12–0.16 mm, to keep the skull and finger detail.Walls / infill: 3 walls and 15–20% infill. The bowl arm carries weight, so don't go below 3 walls.Orientation: print upright on its base.Supports: yes, for the underside of the bowl and its arm, the chin and the raised hand. Tree supports work well. Build a custom support under the bowl rim if the slicer misses it.Finishing: sand, prime and paint in bone white, or leave it in a bone or cream filament as pictured.