This is my Retro Camera Flowerpot design.You can paint however you want! Print different sizes of them and create a cute corner in your home! :)

Modelling time 4 hours.Polygon count is just 30.000! :)Point count is 35.000This model consists of 11 parts.NO SUPPORT JUST PRINT!

CREALITY CR-10 PRINT SETTINGS

15 CM Height Print Settings

*** Print Base Pot with 0.2mm (200 micron) ***%20 infillNO SUPPORT60 Degrees Bed Heat200 Degrees Nozzle Heat

12 Hours Print Time

*** Other Parts ***

Print all other parts with 0.1mm (100 micron)%30 infillNO SUPPORT60 Degrees Bed Heat200 Degrees Nozzle Heat

Other part print time is 11 Hours.Total print time is 23 hours.You can use sandpaper for the big part if you want it.But I do not think so the little parts would need the sandpaper. :)

You need to glue them together. You can use my design and paints. Or create your own design! :)Share with me please! :)

No Need for sandpaper or any finishing techniques if you use 0.1mm layer height.Hope you like guys!

If you have any question about my designs or anything, please don't hesitate to write me a message!You can also send me a message for your bulk purchase to. See you on next projects!