Sinister Jack O Lantern Pumpkin 3D print model

This stylized Halloween jack‑o’‑lantern prints as a single hollow shell with sharp carved eyes and a jagged grin, perfect for dropping in a flickering LED tealight to create a dramatic glow on shelves, porches, or party tables. The model is optimized for fast, clean PLA prints at 0.2 mm layers and 10–20% infill, with internal clearance for common coin‑cell LED pucks or 36–40 mm tealights; no supports are required when oriented upright thanks to tuned wall angles and bridging. For the best glow, use translucent orange or thin‑walled PLA and add a separate top/plug if you prefer loading from above; include both daylight photos and dark, lit shots to maximize listing trust and conversion. Follow CGTrader’s listing best practices by using 15–25 consistent images and a short video spin to show scale, interior space, and lighting effect.​

Print specsOrientation and settings: print upright, 0.2 mm layer height, 10–20% infill, 0.8–1.2 mm walls; no supports needed on standard 0.4 mm nozzle.​

Lighting: designed for battery LED tealights only; never use open flame. Show a night photo with the LED installed for clarity.​

Visuals: mix clean studio renders with real‑print photos; keep framing consistent and add a short showcase video.​

Policy noteEnsure the model and images are original and comply with CGTrader’s content policy; only upload content you own the rights to.​