Raspberry Pi Neutral UPS HAT Seat 3D print model

The Raspberry Pi Neutral HAT Seat comes with a locking device, a female GPIO Ribbon Cable portal, a male 40 pin GPIO header retaining seat, a ribbon cable runner and two screw holes for securing the device. The locking device is designed with two paddles that lock into the HAT or rest on top of the HAT securing the HAT in place. This unit is best used for storage or when you are using a UPS HAT for charging or as a second power source.

There is a patent pending on the HAT Seat.

Creative Commons License. This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International (CC BY-NC-ND 4.0). You can find out more about the Creative Common License at https://creativecommons.org/licenses/