3D MODEL DESCRIPTION

This is easy to install Geprc Mark4 V2 10 inch 7.5mm arm protector clip only, no boltsrequired, you can install and uninstall this protector without a need to unscrew the motors.

Installation on clip is firm and will allow to keep the motors in place without screws loosing over time, which is inevitable if you put plastic between screw and carbon plate.

3D PRINTING SETTINGS

Standard print settings

Infill 15% minimum

Tree auto support works eleganlty good (see pictures).

Copet\PETG is preferable.

Just clip in place after print