Reusable 4 can holder 3D print model

Holder for 4 cans, and room for a small round label in the middle. Fits standard 330-500ml cans, Kegland Cannular can seamer and cans. Beer, soda, and DIY-cans. Reusable.

Fits cans with 55mm lid. 330ml to 500 ml.

Printed in PLA. Useful to overextrude 4% and/or increase temp a few degrees to promote bonding. Uses approximately 10g of filament (1.75mm). Printed on Prusa mk3s, but files available so you can slice them yourself. Recommend 4 perimeters and printing with flat side down!