Paddle Little Devil spank you very much 3D print model

Looking for that little extra oumph in the bedroom? Have you already tried the dice, the feathers, the fluffy handcuffs and the blindfold, but you found all of it too lame?

Well, have I got great news for you!!

Here is the latest addition to my arsenal of evil toys, the Little Devil paddle with spikes! For all you hardcore lovers out there, I present to you the tool that in one strike will cause up to 300 (!) little droplets of blood to form on the skin of your subject. Just imagine what repeated hits could do!

Be aware, this is NOT a tool for beginners. Experience, trust and safewords are recommended.

The top is covered with 300 spikes, while the back is all smooth and perfect for warming up your victim. In the head there are also slots for 8 additional weights to increase the striking force applied to your target. The weights are standard size M8 nuts and they should fit snuggly in place. For best printing experience I recommend pausing the print when at the layer that covers the holes and then insert the nuts. Superglue could be used if you want to in order to make sure they stay in place, but the tolerances are quite slim so that is normally not necessary.

For best result on the spikes, use a finer layerheight on the very tops, this will result in sharper spikes.

I suggest adding a modifier to the section where the handle meats the head and increase the infill to 60-90% there, in order to maintain structural integrity on powerful hits. In other parts 15-20% infill should do the trick.