This is a custom-designed dual holder system compatible with Creality CFS and adaptable for Bambu Lab AMS units, allowing you to securely mount two units in a vertical stack (one on top and one at the bottom).

The system has been fully tested with CFS units.Compatibility with Bambu Lab AMS has not been physically tested. However, the design is scalable, meaning it can be resized to fit AMS dimensions by comparing measurements and applying proportional scaling.

Design and StrengthDesigned for high strength and durabilityTested using PLA, and the structure proved to be very strongCritical rail support parts:4 walls and 30 percent infillOther parts:4 walls and 20 percent infill

I even sat on it myself out of curiosity, and it supported my weight (just for testing purposes)

Although PLA performed well, for long-term durability and safety, it is recommended to use:

PETGASA

Print quality is very important. Poor print quality may result in damage to your equipment.

Assembly Options

1. Sliding Rail System (Recommended)Requires 10 screws and wall plugs (anchors)All components can be easily found at any hardware storeIt is recommended to use super glue when placing the wall plugs for better stability
2. Simple Setup (Without Rails)Can be assembled using only super glueNo additional hardware requiredImportant NotesFully compatible with Creality CFS systemsBambu Lab AMS compatibility is not pre-sized and requires scalingModular and practical designNo special tools required

LicenseThis model is for personal use onlyCommercial use is strictly prohibitedYou may share photos or videos on social media only if you include a link to my CGTrader pageRedistribution of this model, or sharing it by any means, is strictly prohibited.If someone is interested in obtaining the model, you must direct them to the CGTrader page and have them purchase it there.

Disclaimer

These parts will only achieve their full strength if they are properly printed and correctly assembled.

We are not responsible for any damage or loss caused by incorrect printing, improper assembly, or misuse of the parts.

Do not use the system unless you are confident in the structural integrity of your printed components.

Please note that materials exposed to long periods of sunlight (UV exposure) may lose strength, deform, and become unsafe over time.

By using this model, you accept that we assume no liability for any damage or loss that may occur.