Ju-87B Stuka Oxygen Regulator originally designed for the Airfix 1/24 scale kit. Fits directly over kit cockpit parts. Front & rear items supplied. with a cut down version to fit directly on the front cockpit raised kit floor, that in reality is a well, not a floor panel. Both are fitted flush to the sidewall of the cockpitShould be ok at smaller sizes.Designed for resin printing. Use low layer height & low AA settings to avoid overthinning small parts.

NOTE: The model is made in 1:1 real world scale with M as units. It will probably appear very small when you import it into your slicer if it uses mm as units. For 1/24th Scale, use a scale of 4166.666% in your slicer X, Y & Z If you want other scales, then calculate this figure by dividing 1 by your scale, and then muliply by 100,000 . EG 1/32 is: 1/32x100,000 = 3125.000%

Painting: The pipework is black. The Valve body is Cast aluminium, with brass parts, and a black face to the top of the round pressure gauge. The casing is interior Grey-green, RLM 02, with a black serial plate on the front top. The bag inside the case is a leathery brown rubber material. As you might find in an old surgery. It is Not an oxygen bottle, but a bag. Bottle were outside of the cockpit space, to the rear or in the wing.