Four printable airbrush spray masks for adding mottled pre-shading effects or camoflage to your models. 3 mottle patterns and one stripe / grain pattern. Each one loads at 120x150mm and has a thickness of 0.6mm. I have tested these using standard PLA and TPU95 with success on A Bambu P2s. Obviously the TPU is quite floppy when that thin, but it will conform to curved shapes very well.

Printing:The default settings are for PLA, printed in 3x0.2mm layers, with a 0.4mm nozzle, on a heated bed at 55C. No brims, no supports.Print first layer at slow speed for best results.

If you want to scale up or down a little, then leave the z dimension alone unless you specifically want to adjust the thickness & number of layers. Remember that your thickness should ideally be a multiple of your layer thickness. IE The default 0.6mm thick mesh, produces 3 x 0.2mm Layers. Make sure your bed is clean and completely grease free. The striped mask is the least tolerant of bed adhesion issues.

Not for resale!