I created a nice little caliper holder that requires no supports. **NOTICE: **This will not work with all calipers! These are cheap $20 calipers bought from Amazon. If your calipers look similar to the ones shown in the pictures, it will likely work fine.

EDIT: Added a version with a hole for a magnet! The hole will fit a 10mm wide by 3mm thick magnet. Super glue it into place.

Mount your calipers to various surfaces with double-sided tape. You can also use the included version with screw holes if you'd like a more secure attachment.

The version with screw holes fits 1" drywall screws perfectly. Print in either PLA or PETG (PETG recommended) with .16 or .12 layer heights for best results. The model shown in the pictures was printed with a .16 layer height.

Use at least 3 walls/perimeters, and 5 or more top shells/layers for best results.

This license applies to this file: Creative Commons - Attribution - Noncommercial - Share Alike