M
2021-01-09 22:47:56 UTCmac78
What's the best way to print these, at an angle maybe?
Useto navigate. Pressescto quit
3D printer Anycubic PHOTON S filtration unit 3D print model
Description
Filtration unit for Anycubic PHOTON S 3D printer. If you are annoyed by fumes which comes out during the printing, this will be the solution for you!If you will fill the lower side of container with the nonwoven fabric, then with the wadding, after that you have to fill it with activated carbon and cover with wadding again. No more bad smell will come out just pure air. When the cafbon will be full you will notice with smell again. Than you will easilly replace it.
NOTE: Model was updated.
J
2021-01-09 23:27:53 UTCjirak-martin
Helllo, yes try to angle it, that it was how I printed. But I think, that you can print it directly on the plate.
Similar Models
to 3D printer Anycubic PHOTON S filtration unit
Users who bought this item also bought...
