This is a 3d printable fender stratocaster HSH standard body. you will need to print off all 15 parts then sand down the edges and glue them together. These take 2 spools to print at 15-20% infill. This body is setup to use standard strat parts. To ensure they all go together properly make sure the printing orientation of each part is following the same direction as the last printed part. This is needed because even with perfect printers there is still a slight tolerance issue between axis and matching the direction mitigates that issue. PLEASE ensure your printed is calibrated in all axis directions before printing. If you do not your neck and bridge will not fit properly.

These files are provided for PERSONAL USE ONLY. I DO NOT ALLOW the sharing or redistribute of these files or any derivatives / remixes, or to use them for commercial purposes, including selling the printed models. If your are intrested in selling them please contact me.

Would you like to just have one made instead, Check out our ebay shop here: www.ebay.com/usr/justgoodvides3d