this is a case for the bigtreetech tft35 v3compatible with the wifi module, this needed a lot of time to perfect .Intended to be used on the Anycubic mega/mega s can be mounted on any flat sheet with a rectangular hole big enough .easy access to the touch screen , sd card and usb .

NOT COMPATIBLE WITH THE E3 SERIES OF MOTHERBOARDS( of course compatible with the skr 1.3/1.4/1.4 turbo ecc)

3D PRINTING SETTINGS0.1 to 0.2 will workjust the Main body will need a little support ( print it with the front facing the bed )if the holes are a little thigh for an m3 screw you can just touch them with a drill bit or even use a screw driver bit ,torx are the best but flat bits will work too