This high-accuracy trim retainer clip is engineered for Renault Clio models to secure exterior door moldings Taurus side guards, protective strips, or internal door panels. Reverse-engineered from the factory fastner dimensions, it directly replaces missing, brittle, or broken OEM clips. The model features optimized snap-fit retention tabs to hold body panels flush against the sheet metal, eliminating alignment gaps and preventing panel vibration rattles.

Print Recommendations

Material PETG, ABS or ASA ABS or ASA is highly recommended to provide the necessary structural flexing during panel snap-in without fracturing, while resisting cabindoor-cavity heat cycles

Layer height 0.20mm to 0.12mm optional Moderate to low layer heights ensure the locking tabs print with sharp definition

Infill 4060 Since this is a small functional fastener, increasing the perimeter wall lines is critical for maximum shear strength

Supports may vary depending on the model orientation and print bed direction. Please consider your slicers recommendations

Copyright and usage note This model is intended for personal use and spare part replacement only. Commercial production requires licensing.