A chunky, cute-creepy skeleton in an oversized hoodie, baggy pants and sneakers. Its skull peeks out of the hood with big hollow eyes, and its ribcage shows through the open jacket. The hoodie is sculpted with deep wrinkles and a zip, and the stance is relaxed, with hands tucked into pockets. It stands on its own feet, so it needs no base. It looks great printed in a colour-change or gradient filament, as in the photo, where the pink-to-orange and purple-to-blue prints shift colour from head to shoes.

Use cases:

Halloween decoration and party table pieceDesk, shelf or monitor-top buddy, and a gift for goth, horror and streetwear fansCollectable figure to print in sets or in different colour combinationsFidget-free desk toy for classrooms, offices and gaming setupsPainting project, with the hoodie and sneakers as separate colours

Recommended print settings:

Material: PLA, ideally a gradient or multicolour silk filament for the look in the photo. Matte PLA works well if you plan to paint it.Layer height: 0.12–0.16 mm, to keep the ribs, skull and hoodie wrinkles.Walls / infill: 2–3 walls and 10–15% infill. It's decorative and compact, so it doesn't need to be strong.Orientation: upright on its feet. Add a brim for the narrow shoe soles.Supports: minimal. The hood brim, the chin under the hood, the arms away from the body and the jacket hem may need small tree supports. Check the slicer preview before adding any.Finishing: gradient filament needs no painting. Otherwise, sand lightly, prime, then dry-brush the ribs and hood folds to bring out the detail.