Christmas Special Cute Santa stuck in chimney.

How it works? : Its a print in place model and needs no support. After printing just push the santa body from below and give it a little twist that way the body of santa will not go into the chimney and will stuck in the position, same way twist it other way around and boom santa will despair in no time.

Make sure to upload a make after printing, I'll love to see them.

Happy Printing:)

Print Setting info:

STL and 3MF files are included. If you use the 3mf file, please remember that it is a painted project file for your convenience. You must check your material/printer/settings to make sure it works correctly for your printing project.Print-in-Place, No supports needed.

Multicolor 3MF (Compatible with Bambu Studio)

0.2 Layer Height ( Use 0.12 or 0.16 layer height for better quality

10%-15% Infill (I recommend Gyroid, Honeycomb or Grid)

3 Walls (Assuming 0.4mm nozzle. Adjust wall count to account for alternate nozzle sizes)

Make sure you have good adhesion.

I tested this model on scale of 50% to 200%, I do not suggest smaller than 60% for the model. ( I printed it on 60% scale )

Happy Printing :)