Wall mount for Nintendos NES system (US/EU)

You can mount this on the wall or a shelf or a wooden board, so you don't drill too many holes into the wall. You might want to add more consoles:

Fix the ports and supports to the base using the M4×20mm bolts and nuts.

Install your NES system by placing it on the protrusion on the port. On the NES side ther is a groove which receives the protrusion.

You can hang your controller by it's cable on the pegs on the bottom side of the basis.

To print:

2× NES port1 × Base left1 × Base right2 × Support

Additional items needed:

4 × M4×20mm Bolt4 × M4 Nut4× Screw for installation

3D-Printing Settings

Best in 0.2mm and lower, but 0.3mm work just as well.

Use supports only for the connections between basis and port part.