Whilst walking around the factory at work, I noticed oil drums are now stored on large cabinets for safety. These cabinets contain drums of oil, and I thought these cabinets would be ideal for any modern depot as a scenic extra.

This design is for printing on Resin printers, and the cabinets have closed and Open doors; they are specifically designed for Resin printers. I have also done a set of designs for FDM printers.

The resin version are not solid objects and have drain holes to reduce the vacuum effect when printing unlike the FDM version.

I tested these resin versions on a AnyCubic Mono 4 Ultra 3D resin printer with a layer height of 0.040 using AnyCubic Water Washable resin.When printing these, the Angle was approximately 35 degrees along the long edge and approximately 40 degrees from back to front (See photos)

The Larger Cabinet is approximately 75mm Wide, 42mm High and 21mm Deep in OO GaugeThe Smaller Cabinet is approximately 42mm Wide, 36mm High and 20mm Deep in OO Gauge

As normal with my designs, there is a balance between accuracy and printability, hopefully not affecting the look of the model too much.

use this link to join CGTrader and download my designs.https://www.cgtrader.com/designers/PJD1974?referral_id=3218445