1/48
Merry Christmas, everyone!
This Christmas themed pack contains the following items:
Note : Just a friendly reminder, but these designs are not colored. The cover images are just a concept.
Santa Claus
This design was divided into two separate pieces. The Santa Claus Duck and the glasses.
This will facilitate the print but also give you the choice to not use the glasses at all (or for those a bit more creative, the option to just use another glass design).
To combine the two pieces, just use a few drops of super glue.
The duck dimensions are the following (mm):
Height- 76
Width- 54
Depth- 81
Mrs. Claus
This design was divided into two separate pieces. The Mrs. Claus Duck and the glasses.
This will facilitate the print but also give you the choice to not use the glasses at all (or for those a bit more creative, the option to just use another glass design).
To combine the two pieces, just use a few drops of super glue.
Since you may not want the snowflake pattern on the apron, I've decided to add another model without it. That way you can add your own design to it!
The duck dimensions are the following (mm):
Height- 80
Width- 54
Depth- 81
Raindeers
For the raindeer with a sweater, you can see that it already has a design in it, but I'm adding an extra model where the sweater is design-free. Just in case you wish to add your own design to it!
I've added stars to the scarf, but I'm adding an extra model with a clean scarf just in case you wish to give it your own flavor.
These are the dimensions for each raindeer duck (mm):
Height- 91
Width- 52
Depth- 81
Santas's Elf
The duck dimensions are the following (mm):
Height- 77
Width- 54
Depth- 81
Elf on a Shelf
The duck dimensions are the following (mm):
Height- 104
Width- 52
Depth- 81
Sculpting software used: Blender
Render method used for the previews: Cycles
Filament: PLA
Slicer used to 3D print: Ultimaker Cura
Settings I've used to 3D print:
Standard quality - 0.2mm
Infill - 20%
Supports - You will need supports for the duck's bill aka beak and antlers (for the raindeers).
Speed - 50% first 20 layers and 100% for the rest
Plate Adhesion - Skirt
Cooling - Enabled
Travel - Retraction Enabled
