This is my NightShade Mandalorian helmet, it is a mashup of my version of the Sabine Wren Style helmet with obvious Marvel influence. All pieces come apart and press fit, some might need extra clearance depending on your printer settings. It prints nice and thick with room for pads. This helmet will print on a CR10S-pro with NO supports in the center. The screens on the rangefinder can be printed in translucent. Glue for the parts is an option depending on how tight they fit with your print, using screws for the ears would be a nice option so they can be exchanged, most parts should fit snug though. The range finder shaft comes with a cyclinder to mount it to the helmet that I labeled as BOLT. This can be replaced by an actual bolt, I created a hole all the way through the ear to allow more room but depending on the bolt size, you might need to adjust the hole.

The alignment pins for the back piece fit directly into my own prints helmet holes, but you will need to trim the length with a pair of cutters. I made the pins long so they were easier to press into the back piece to glue and also easier to make sure the holes inside the helmet are cleared enough for them to fit. I myself like to insert the pins into the back piece, glue the pins, trim the pins, and then starting on one side, snap the back piece onto the helmet. Since the back piece is the same shape of the helmet but with pins, you'll have to flex it just a bit to get it to reach the last hole.

Check out our insta and fb at GrizzlyMountainDesigns to keep up with our modeling and current builds! For even cheaper deals checkout our patreon.com/grizzlymountaindesigns

This is a solid file that fits angled on my CR10s-pro bed (300x300) it is not split.

Please, Do not share/resale the 3d model

Please feel free to message with any other questions or reguests! I do TONS of modeling requests.