A friendly yet scary fella who roams the battlefield bringing decay and friendship.

Pre-supported miniature sized for a 60 mm. base but it could fit in smaller ones (the one in the photos is 60 mm.)

Printing paremeters:This models are intended for resin printers and tested with an Elegoo Mars and an Anycubic photon s.

The support are made for 0,03mm layers and the test prints you see in the image were made with this parameters as well as 6-9 seconds of exposure per layer depending on the resin.

I highly recommend to remove the supports after cleaning but before curing for better results. For the parts where the supports won't come out easy or are attached to delicate parts I also highly recommend to use clippers.