Disorganized Babyzerker 3D print model

Hello,i made this modell because i want to start a new smaller project.This is the first figure and, if it gets enough likes i will make more of them (i have some ideas).

Seriously my son asked one question: Is disorganized the bad faction? I had to think about it. So i told him by this modell, that nobody is born like a bad guy, you only grow up in your system.

So i think he understood what i mean and...man this babyzerker is cute, isn`t it?

Awwww boy, you make me proud. You built a skulltower :)

There are following combinations1) 1-Part-Modell on Base2) 2- Part Version (Legs and Body)3) 3- Part Version (Legs, Body, Backpack)3D printing settings

Its a 3 Part-Modell for easier print (FDM-friendly) and painting.If you are skilled you can choose the One-Part-Modell on a Base.As you can see on my pictures its possible to print this nice guy.

For smaller prints your layerheight should be 0,1mm.If you print it bigger (like me) choose 0,2mm layerheight.Make sure you remove the supports gentley. The Chains on the Helmet are stable, but not indestructable.