,1-1 gear ratio, good for dry herb,oll the part printed ,glue toghter with super glue, i print the body with pla and oll the other parts with super pla(stronger) .i print the body standing up(normal position) and set the support over hang angle to 87 .that way the support stop after the drawer, and i didnt have support inside, layer hight-0.3,print speed -40, adhesion -brim,support- everywhere -overhang angle-87,,3.5 hours./ drawer-same like the body with out the support,/for oll other parts -infil 60%,print speed 30,layer hight0.2,wall thickness 1.2,top bottom thickness 1.2,bottom top layer 5,support(when needed)over hang angle-50,adhesion -brim,(if printed some parts toghter i use in the special modes-print sequence-one at a time and then in edit-arrange oll models so the extruder work cleaner, temp-220 ,build plate-60 (for the body build plate temp-40 Because of the print time is longer and the body might Twitch.Please contact me for any questions