A futuristic gorget design with a structured high collar, layered tech paneling, and a distinctive ribbed neck section that gives it a sharp sci-fi silhouette.

*Perfect for cosplay, futuristic costume builds, convention wear, display mannequins, or scaled action figure armor.*

Measuring Instructions

This is a wearable neck armor model, so measuring carefully before printing is very important.

For cosplay wearable scaling:Measure your neck circumference where the collar will sitMeasure the base of the neck / collar width across the frontMeasure the distance from the collarbone upward to the height you want the collar to reachCompare your measurements to the internal dimensions of the model in your slicerScale uniformly (X/Y/Z) first, then check the fit again around the neck opening, shoulder spread, and chest coverageImportant fit note:

*For gorgets and collars, the most useful checks are:*inner neck openingfront collar heightshoulder clearanceoverall width across the upper chestcomfort around the jaw and throat area

Tip:It is usually better to scale slightly larger and fine-tune the fit with padding, foam lining, straps, or careful heat shaping if needed.

Recommended materials:PLA-HT / FPLA for better wearable durabilityPETG for more flexibility and impact resistanceElastomer-based / flexible filaments for softer comfort-focused experiments

Finishing TipsPrime with grey, white, or black primer depending on your final color schemeSand and fill layer lines if you want a polished armor finishThis gorget works especially well with:white and silver sci-fi finishesblack and gunmetalmatte titanium greyblue-grey futuristic armor tonesred, black, and metallic accent schemes

To enhance the design, try:

darker shading in the panel recessessubtle edge highlights along the collar ribs and chest linessatin or gloss varnish for a sleek high-tech finishmetallic dry brushing for a slightly worn combat look

A hairdryer or low heat gun can be used carefully to fine-tune the fit of wearable parts after printing.