This set comes with 7 different kunai that can be mounted to the plate carrier's MOLLE system. Easy to install and remove, yet strong enough not to worry about accidental removal. A base kunai is also included as a bonus.

Printing suggestions

• Print the mountplates on thier side to ensure maximum structural integrity

• Print with 3 exterior wall and 25% infil

• print the kunai by placing one flat side down on bed and add supports ( this will have the model kicked up at an angle but that is desired for strength )

• If possible use paint on supports to remove the supports in the hole at the end of the kunai to make clean up faster and easier

• Sanding may be necessary on the mount post and inside the hole at the end of the kunai depending on your printers precision

• For maxium detail add para cord sleeve to handel ( cut cord, pull out interrior cord(s) and super glue the sleeve to the handel in a spiral)

• do not throw these at anyone they are meant for looks only.