3D MODEL DESCRIPTION

A rugged, stylized bracelet designed to look like interlinked carved bone segments, wrapped with organic rings.

Measuring Instructions

This is a wearable item — measure your wrist with a caliper:

Measure your wrist diameter (across the wrist, not the circumference).

Measure inside diameter of the printed bracelet in your slicer (use ruler tool).

Scale uniformly until the inside diameter of the bracelet is ~10 mm larger than your wrist diameter for a comfortable fit.

Because the bracelet has thickness, always check the INSIDE measurement — not the outside.

For very tight fits, warm the printed part slightly (hairdryer/low heat gun) to make micro-adjustments.

Printing Tips

Works with PLA, PLA+, PETG.

Layer height: 0.12–0.2 mm.

Supports usually not required; use light supports only under the hook clasp if needed.

Print orientation: flat on the inside ring for strongest result.

For resin printing, use medium supports and keep detail resolution at 0.03–0.05 mm.

Finishing & Painting Tips

Prime to unify the surface.

Use dry brush with beige/ivory to highlight “bone” ridges.

Use brown/sepia wash to sink into recesses.

Matte clear coat gives a realistic organic finish.