This was a work I've done for my new glasses. Maybe somebody else loves it.I've used magnets for the case and I still need to get it smoother over the magnets.

CASE: - inside case is not included - picture for engraving is not included

Holes are for case:

• big ones: 10mm diameter and 11.5mm deep - in the pictures are 9mm magnets used - measure it!
• small ones: 4.1mm diameter and 11mm deep - in the pictures are 4mm magnets used - measure it!

Size inside:147mm long and 47mm width and height is 26mm - minus the place for the magnets

I've anodized it with 20-110V from the middle to the outside I've engraved it with a CO2 30W laser - the only I had at this moment.

Sunglasses holder for Rigards RG0105ti in titanium: (As a free addon if you have such eyeglasses)4 holes: 2.15mm diameter and about 1.5-2mm deep

keep in mind that 3D printing in titanium can be expensive!