Model created in Zbrush. It is watertight and ready for printing. It was created with molding and casting in mind. PLEASE NOTE THE UNDERCUT BEHIND THE CROSS AND ARM and make sure Your casting method will be able to accomodate that. It is a tough place that might be prone to breaking if the model is scaled down too much.
Inlcudes a highpoly, quad OBJ (around 3.5 Mil polys) and a decimated, optimized STL (1 Mil polys)
Nominal size (although easily adjustable in any 3D software) is:
90 mm tall
56 mm wide
6.81 mm deep
VOLUME: 3.19 cm3