Skoda Octavia MK1 Ashtray Gauge Pod for Racing Meters 3D print model

Model: Ashtray holder converted for gauges – Skoda Octavia I (MK1)Designed for: 2× 52 mm additional gauges (oil temperature, boost, AFR etc.)

Recommended printing

Material: PETG or ABS (due to higher heat resistance in the car). I do not recommend PLA - it softens in the sun.

Infill: 20-40% (grid or gyroid recommended).

Layer height: 0.2 mm (or finer for a clean surface).

Supports: depending on the slicer - usually necessary at angles >45°.

Orientation:I recommend as shown in the picture in Blender

⁇️ Important notice

This model is provided only as an STL file for 3D printing.

The author is not responsible for bad printing, inappropriately selected settings, or possible damage to the part during use.The buyer is responsible for the correct print settings, material selection and the final quality of the result.