CoolerCan Koozie or skinny 12oz cans

Due to the popularity of the standard 12 oz version (and a lot of requests), I’ve adapted the design to fit skinny 12 oz cans. THis free version has my branding on the bottom, I have a version with no branding on my patreon for subscribers.

This version keeps all the same functionality:

Built-in handleDrop-in fit with light detents to hold the can in placeRemovable lid with a straw holeRotatable lid so you can position the opening where you wantThe overall concept is the same—just scaled and reshaped for the slimmer can profile.

This version uses:

The same spoutThe same push pins / hardwareThe same general assembly approachOnly the main printed components are new:

BodyLidHandleEverything prints separately and assembles by hand:

No supportsNo AMS requiredNo glue or hardwareAs with the standard version, fit can vary slightly depending on printer and filament. If needed, you can scale slightly (typically 100.5% or 99.5%) or lightly sand contact areas to dial things in.

Thanks for supporting my work — this is an original design and reflects the time and care that went into creating it.