Amazing!

good

I have printer at least 6 different versions of The Red Hood. Needless to say he's my favorite character. This model is by far my favorite out of anyone I've seen/printed. I have printed 20+ helmets and what I absolutely love with this one is how the helmet was split. I've never printed a helmet split or not that needed so little supports. I am incredibly impressed. Didn't know this until after I printed this helmet but major bonus points for have built in magnet sections. Only con I came across is the jaw section at the bottom makes scaling to size difficult. If you scale it to fit your head the jaw won't allow you to get it on over your head. If you scale it to accommodate that then the helmet is too big. I've printed the middle section a few times before I got a good balance.