Latest addition, 3D printed FuzNuz Hoof Rasp handle. Recommended to attach with epoxy, but it might be able to withstand being pounded in if well printed.

This particular design also includes an end piece handle for the rasp that will likely fit on most horse hoof rasps. I designed it trying to make a general fit piece, but the actual design dimensions are for 0.25 inch thick rasps that are 1.75 inches wide. Epoxy this piece on as well.

The prints are designed to be printed as towers with the open slot on top. No support material is required. The main handle may become somewhat wobbly, so make sure you have good bed adhesion, but the results are well worth doing it upright. Sideways printing with supports are likely to crack along the laminate lines,

As always, please leave design comments, feedback, or design requests.