This is a case for RPI Zero.Why another 101st case? I want:

• printable
• looks good
• breathable for better cooling (in typical solid cases my RPI sometimes freezed)
• suitable for passive FAN height at least 10mm (it is max. 12mm)
• all connectors have to fit to the end (some cases prevent this)
• easy taking out the uSD card just by hand
• no unnecessarily parts and edges or too big

Allmost all cases on net was solid or without proper cooling or did not met my requirements, so here it is;-)

To complete you need 4 pieces of screw M2,5x8mm. Can be also M3x8, but then you have to drill RPI Zero to 3mm (it is 2,5 from factory).To print it I used PLA, 20% infill, no supports, but can be printed by almost all materials.