very nice design. I have started preparing to build rc plane using this design.
hope everything goes well inshaallah
Can someone please tell me the CG from this plane?
I assumed it would fit 220x220 bed but it does not. I can get print on cura at 80% . Hope it works. Any other suggestions?
You've provided valuable information, but I'll still need the wing area in square meters to perform a more accurate thrust calculation. The wing area is crucial for calculating the lift generated by the wings. Once you provide the wing area, I can proceed with the thrust calculation.
Or just provide Average Chord Length (in meters)
Where is CG location of this model?
if we print this model, then is it able to fly with rc setup?
