This design was made using the dimensions of the paint bottles I use although I did adjust it for Citadel paint bottles. I might do a Vallejo one soon but for now this is the design I have. If you have any comments or recommendations I'm open to them.

Should be pretty straightforward to assemble but the steps are as follows:

1. Insert 608 bearing into the middle section of the Main Bottle Holder.
2. Insert Main Threaded Rod into the Main Bottle Holder.
3. Screw the Main Threaded Rod into the Base.
4. If you plan to use the extensions, screw the Extension Rod into the Main Threaded Rod.
5. Insert the Additional Bottle Holder into the rod and adjust.
6. Repeat if you plan to use more.

Might require some sanding as some parts were made to fit tightly.

15% infill with lightning pattern for the main bottle rack.15% infill with zig zag pattern for the rods.