After watching the infamous video from a few years back where Z-Corp prints a fully working wrench i decided i wanted to do the same thing on my own printer.

Now, i´m not talking about a "print-several-pieces-and-then-assemble" version which there are already a ton of on the internet.What i wanted to do was something i could print and that would actually be fully working straight out of the printer.I like to think i came pretty close. All you need to do is to remove the internal support and your done!

Keep in mind this is a proof of concept, i just wanted to see if i could do it.

This project is licensed under the Creative Commons - Attribution-ShareAlike 3.0 Unported (CC BY-SA 3.0): http://creativecommons.org/licenses/by-sa/3.0/deed.en_US