This is my Wand Holder design for your wand collection.You can have it with VERY LOW PRICE!Model made by me. YOU DON'T NEED GLUE or Anything! The models are like puzzle pieces!

Modelling time 2 hours.Total polygon count is just 10.000! This is a Print Ready model!

CREALITY CR-10 PRINTER SETTINGS

Print HOLDER PARTS with 0.15mm (150micron)%30 infill60 Degrees Bed Heat200 Degrees Nozzle Heat ( Depends your filament )Printing time 3 Hours for one holder.

Print CONNECT PART with 0.15mm (150 micron)%30 infill60 Degrees Bed Heat200 Degrees Nozzle Heat ( Depends your filament )Printing time 3 hours for connect part.

Print WAND COLLECTION TEXT PART with 0.1mm ( 100 micron )%80 infillTurn on support, set it up for 50 degrees.60 Degrees Bed Heat200 Degrees Nozzle Heat ( Depends your filament )Printing time is 1.5 hours.

Total Print Time is 10 Hours only!

I hope you like guys!

If you have any question about my designs or anything, please do not hesitate to write me a message! See you on next projects!