Modular stand for Hot Wheels, Matchbox, etc

For best results I recommend placing the supports as shown in the last photo. In CURA I used free Custom supports plugin (also you can use automatic supports, but this can cause problems)

Printing settings for PLA:

-Extruder temp: 200-210-Bed temp:60

-Infill 13-15%-Top layers: 3-4-Bottom layers: 2-Wall line for 0.8mm: 2

-Supports: Yes (put it as shown in the last photo using free custom supports plugin in CURA for better result)-Support density: 10%-Support Z distance: 0.2mm-Support X/Y distance: 0.3mm

-Built plate adhesion type: Brim (recomended)