Classic slim fit case for Airpods 2nd generation (2019).I make it on a Prusa i3 MK3 3D printer. I was looking for the softest rubber fillament, so I used one from Spectrum fillaments - Perfect, lil stringy but that softness is how I expect rubber material.Everything works fine, even the supports are perfectly ripped off.
My Slincer settings: Material: S-FLEX 90A (Spectrum fillaments)
- nozzle diameter 0,4mm
- extruder temperature: 240°C
- bed temperature: 55°C
- height: 0,2mm
- full layers: 5x top, 4x bottom
- infill: about 20% or lower
- perimeters speed max: 20 mm/s
- small perimeters speed: 10-12 mm/s
- infill speeds: 25 mm/s
- Supports speed 30 mm/s
Of course if you know your printer you can print on your own settings.
Give me comment or rewiew and enjoy the model
