Loading media

DESCRIPTION

This model is based on the Starship S28 + Booster B10,witch was launched by SpaceX for the third test on march 14,2024.
Modeling scale is 1:100. The highest point is the launch tower, with a height of 1500mm; Starship height 500mm; Booster height 700mm;The height of the launch base is 230mm.
It is recommended to print at a scale of 1:200, which reduces the model to 50%. The height of the starship and booster is higher, and it is recommended to print it in two parts. If Starship and Booster do not print separately, you do not need to print Model Split Connection Ring X2.
The launch tower is printed in shards and then assembled, which may require the use of glue. The connection between the starship, booster, and launch base uses magnets, and 34 10*4mm magnets (actual thickness 3.8mm) are used when printing at 1:100 ratio; 20 x 5*2mm magnets (actual thickness 1.9mm) for printing at 1:200 scale
For the assembly process, please refer to the video of BILIBILI:：
https://www.bilibili.com/video/BV14E421G7wD/?vd_source=544ec62f87a0a7ad9b312322c5641121

Related Tags

airplane

s28

b10

sci