Ice Warriors - Squad of the Imperial Force

Ice Warriors - Squad of the Imperial Force 3D print model


The Ice Warrior squad consists of 8 soldiers, a radio operator and a sergeant. Each warrior has several weapon options.

Models have been prepared and tested for 3D printing. We recommend to print in resin. Printing assumes the use of supports.

This model has pre-supported files (SLA). Please note that not all of our models have pre-supported files. Pay attention to the description.

We will be glad to any suggestions and ideas for expanding the range of our models. We will also be grateful for a photo of a decorated model according to your vision.

Sincerely Yours, RedMakers.


  • Private Use Only,
  • No Derivatives,
  • Non-Commercial.
realgnostic 2021-08-12 20:18:49 UTC
I love them, I cannot decide what to choose - Ice warriors or Janissaries - for my army... Is there a chance for those hats/helmets to look more as russian ushanka?
redmakers 2021-08-13 09:17:57 UTC
Hi. Thank you! We have more units in the Ice Warrior regiment, so it will be easier to assemble an army. Unfortunately, we don't have the ability to make custom edits. There just isn't enough time.
blueskykida 2021-06-29 23:54:55 UTC
Any chance these come with alternative heads with goggles down?
redmakers 2021-07-01 07:35:18 UTC
This is a good idea. We cannot promise. But we'll definitely put a note on the list for possible improvements.
Item rating
6 0
arkisart 2021-08-03 18:02:14 UTC
Excellent models, great detail overall, nice dynamic poses and easy assembly. After printing a platoon of these, I can recommend a few notes for anyone looking to print these. 1: Depending on the software you're using, the presupported models may have a few areas that read as "unsupported." Overall, the supports are excellent, but make sure to double check everything. 2: There are a few problem pieces that I have encountered; namely any of the pistol grips and rifle stocks that are "free" (ie. models that are not holding the rifles in a ready stance) as well as the barrel of the laser pistol on the Sargeant. These parts are extremely thin, and will often snap off as you are attempting to remove supports, sometime no matter how ginger you are. Now this might change based off of the resin you are using, but if these models were ever updated, I would recommend that these parts be beefed up by even a tiny amount to make them a bit less fragile. Not a huge deal by any means, but something to looks out for. Otherwise, awesome overall.
Ice Warriors - Squad of the Imperial Force
Custom License 
Ice Warriors - Squad of the Imperial Force
Custom License 
Response 99% in 12.1h
3D Print Modeling

3D Model formats

Format limitations
  • Stereolithography (.stl) (2 files)454 MB

3D Model details

  • Publish date2021-04-14
  • Model ID#2983966
  • Ready for 3D Printing