It looks great in the picture, but the only problem I had was it took me about 3 hours to support the bear with all of the tiny overhangs and islands. I tried the auto support the first time because there were about 500 islands that need supports. Then when I ran the proximity checker there were numerous supports that were too close to the model, and with all of the other supports around them I couldn't see the ones needing to be moved. I haven't tried printing it yet, but I am sure I will have to clean out the vat afterwards. Update: 10-16-2022 I have tried angling this model front, back, upside down, sideways, and no matter how I put it there is more than 3000 islands that need to be supported. I don't see how this model will print successfully on a resin printer.