Nautical cleat for ships, boats, warfs, docks, and quays. Watertight for 3D printing, also possible to use in CGI, though might need to reduce polygon count. Model is full scale, so if 3D printing, be sure the first scale the model according to your needs.
A horn cleat is the traditional design for a cleat, featuring two “horns” extending parallel to the deck or the axis of the spar, attached to a flat surface or a spar, and resembling an anvil. Traditionally, the line from the boat should initially run to the far (left) side of the horn cleat rather than close (right) side. Cleats are a use for mooring boats and ships to docks and wharves; also used on sailboats at smaller scales for tidying and fastening various lines.