Very nice looking model, however, I did find what appears to be an omission by the designer. Where the legs attach to the shoes are supposed to be plugs and slots or registration keys and holes, there are only the square holes on both bottom parts of the legs and top parts of the shoes. This model also had a couple of pieces that came up having "holes" in them making them non-manifold, but was fixed through Azure3D. Update 08-29-2021: Well, now that it has been several days I have completed the printing and have found several issues with this model. The first issue is the lower dress has three spots in it that are too thin to print, on both my resin printer and my FDM printer. On the FDM printer the areas that are too thin to print leave a triangular hole in the lower back side of the lower dress. On both the resin print and the FDM print there is a section on the right side of the dress that is too thin to print and looks like there is a slit nearly all the way up. The second, and biggest issue is there is NO WAY to fit the head inside of the hair as it is printed. I had to use my Dremel tool and sanding drum to really sand away a good portion of the inside of the hair just to get the head to fit inside, then I had to cut the registration peg in half just so the head would fit. After that it was a matter of doing a ton of sanding and scraping just to get the different pieces to fit into their slots. The model looks good in the pictures, but is a royal pain to get it to fit together in real life!!!