NOTE: THE JOKER MODEL IS SOLD SEPARATELY, THIS FILE IS ONLY FOR THE ARSENE MODEL.

This massive figure was made to stand together with the previously posted Joker (https://www.cgtrader.com/3d-print-models/miniatures/figurines/joker-persona-5-2b5cb38c-d3c4-4a5c-87fe-167665abbd61). This file comes with 2 base models, one that has a slot for Joker and one that doesn't.

When printed at 100%, everything stands at 51cm tall, 60cm wide and 38cm deep.

In order to optimize balance and prevent warping or tilting, since the figure is very big, it is reccommended that when printing the wings they are set with a very low infill. For the base, wind and auras pieces, print with a higher infill, as to make the center of mass as low as possible.