The Daily Prophet Gate - Harry Potter 3D print model

Hey guys!

This is my The Daily Prophet Gate model, Inspired from Harry Potter.

Modelling time is about 4 hours!

ONE PART

High-Resolution model

I did not use support for bricks and results are pretty good. But you can use it if you like. I did use a lot of sandpaper for the layer traces. You should print it with 0.1mm if you don't like those layers to seen

I hope you like it guys!

If you have any questions about my designs or anything, please do not hesitate to send me a message! See you on next projects!

3D PRINTING SETTINGS 150micron (0.15mm) Layer height %20 infill NO SUPPORT NO RAFT 60 degrees Bed heat 200 degrees Nozzle heat

Model Height is 17cm Printing time is 24 Hours