Seedling Transplanter 3D print model

This serves as a new way to transplant a seedling with minimal damage to the plant and very little mess. The top is filled with dirt and a seed is planted and once it has sprouted and grown strong enough for transplantation, the bottom rod and disk is pressed upward and forces the plant upward without damaging the root system as is what happens in other methods. The model is comprised of three parts, the upper cylinder, disk, and rod. The disk is placed into the bottom of the cylinder and the planting takes place on top then when ready to remove the plant the rod is placed in the in the bottom opening and pressed upward. There is also a small drainage hole where the rod is inserted to allow water to escape.