This is a 15 block stand that will hold your General Hydroponics Rapid Rooter starter blocks upright during the germination/cloning stage.

Prints with out support. Has a brim that is easily pealed off to assure a warp free well adheared print.

Print 1 grid and 4 legs.Assemble by inserting legs in the leg holes :)

The one pictured in the images was printed on a Lulzbot TAZ 3.1 in PLA with a .28 mm layer height, .30 mm initial layer, .15 mm linier fill and about 2 hours to print.

Happy gardening!