this 3D mushroom lamp is a very intuitive design kids like a lot very simple design with E27 light bulb and holdervery few parts only 3 prints neededfor the base :print as you like for the head no support neededtemperature and speed depends on your filament and printermake 4 processesfirst: 5% infill 0.2 layer height (until the height of the thread)second process : 0% infill 0.2 layer height until 75mm (so when the light is lit you don't see the infill lines)third process :0% infill / 0.1 layer height until 95 mmfourth process: 20%infill 0.1 layer height (so it's not weak in the top )for the white spots in the mushroomplace the all on the bed (cavity facing the bed)use raft and sequential printing with 0% infill and 0.1 layer height and 5% support